The Floor Pro Community Karndean International

Go Back   The Floor Pro Community » Public Forums for the floor Pro, Do-It-Yourselfer & Consumer » Ceramic and Stone Q&A

Stand and Seal Health Problems


This discussion, "Stand and Seal Health Problems", in Ceramic and Stone Q&A (part of the category Public Forums for the floor Pro, Do-It-Yourselfer & Consumer), begins, "Last edited by TFP Admin : Today at 12:20 AM. Reason: as per www.ajc.com permission policy WHOOPS!!! MISSED THAT. And ..."

Log in
User Name:

Password:

Not a member yet?
Register Now!
Advertisement
Support TFP

   Please help me cover the overhead and cost of TFP with a donation via PayPal. Click the link below. Your donation will be very much appreciated. Donating is easy, fast and secure.

   Thank you, TFP Admin





Donate to TFP


Reply
 
LinkBack Topic Tools
Old June 16, 2006, 03:41 PM   #16
Tile Expert
TFP donor badge
moderator emeritus badge
author badge
charter member badge
 
Join Date: May 2006
Location: South Central Nebraska
Posts: 1,033
Send a message via ICQ to Bud Cline Send a message via AIM to Bud Cline Send a message via Yahoo to Bud Cline

Last edited by TFP Admin : Today at 12:20 AM. Reason: as per www.ajc.com permission policy
WHOOPS!!! MISSED THAT.


And it's still on the shelves in a new can!

Is it the same old product OR NOT?

Bud Cline is offline   Reply With Quote
Old June 16, 2006, 06:07 PM   #17
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

The aerosol is still the same good for nothing dangerous crap that it was. Check the msds-- you'll see nothing's changed.


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 1, 2006, 11:08 PM   #18
One of the Irregulars
charter member badge
 
Join Date: Jun 2006
Posts: 15

Thank you to the replys I have recieved!


I have added new information to my website http://www.standnseal.com/ Please check it out. I would also like to apologize for the delays getting new info added. I do however have a 4 day weekend to catch up a bit, thanks to SnS digging deep into my wallet so I had to cancel the Family vacation. Sorry if I sound bitter........ but I am! Whew I feel better though venting, lol. I promise to do my best to add info to the site as often as possble, in the future. In my defense though I do have a family that comes first!, and I just haven't had the energy this past year like I used to. HMMMMMMMMmmmm......... I used Stand n' Seal last year in July..... What a coincidence. I DID WARN YA I WAS BITTER! ........ and yes I am cracking jokes but hey a smile even if it is at my own bad joke helps.
Best of luck and health to all!, Shawn

oofda is offline   Reply With Quote
Old July 2, 2006, 08:04 AM   #19
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

Better to laugh than cry, Shawn. I hope like hell that this site becomes everything you've (and the rest of us who've been involved in this) envisioned it to be.


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 2, 2006, 09:40 AM   #20
Administrator
 
TFP Admin's Avatar
 
Join Date: May 2006
Location: teh Ether
Posts: 3,493

Shawn! I have added a link to your website to our Member Sites module that appears on many of the pages of TheFloorPro.com (almost all except for the forum pages). You can see it by clicking on the Home page link in the navigation bar at the top of the page.

I hope this is a long and fruitful discussion for everyone involved.

TFP Admin is offline   Reply With Quote
Old July 2, 2006, 07:40 PM   #21
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

Best link you could've ever added!


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 2, 2006, 07:54 PM   #22
Administrator
 
TFP Admin's Avatar
 
Join Date: May 2006
Location: teh Ether
Posts: 3,493

Thank you Bill. We also have your website linked there too, as well as in all of your messages. I noticed that TheFloorPro.com isn't linked or mentioned on your site (hinthint)

I do appreciate all your participation though.

TFP Admin is offline   Reply With Quote
Old July 2, 2006, 08:04 PM   #23
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

TFP Admin said
Thank you Bill. We also have your website linked there too, as well as in all of your messages. I noticed that TheFloorPro.com isn't linked or mentioned on your site (hinthint)

I do appreciate all your participation though.
I'll GIT R DONE!!


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 3, 2006, 03:27 AM   #24
One of the Irregulars
charter member badge
 
Join Date: Jun 2006
Posts: 15

Thanks again Bill and TFP Admin


My site will never be what I envisioned, because if it was this horrible product would allready be pulled. I will however be satisfied if my site gives the ammo to allow those who were affected to get a fair settlement!, because if they do it will cost them enough money that keeping it on the shelf will make them lose money. They sure haven't pulled it for the safety of the public. All they are concerned about is the allmighty dollar. Sooooo, the way I see it is take away the $, and maybe the crap will go away too. One can only hope. Egads the birds are chirping, I better get some sleep!
Thanks again, Shawn

oofda is offline   Reply With Quote
Old July 3, 2006, 05:16 PM   #25
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

That's why I've talked this stuff down as much as possible. I've even registered on forums and websites just so I could say my piece about this crap, following the same reasoning as you-- they're not going to pull it off the shelves because it's a bad product, so the only other alternative is dry up the reason for putting in on the shelves in the first place. It used to be that I'd send everyone to my thread at John's site. Now, I'll send em to your site, instead.


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 4, 2006, 10:25 AM   #26
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

Re: Stand and Seal Health Problems


I noticed that TheFloorPro.com isn't linked or mentioned on your site (hinthint)
It is, now-- right up there with the other big three on the front page.


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 4, 2006, 10:43 AM   #27
Administrator
 
TFP Admin's Avatar
 
Join Date: May 2006
Location: teh Ether
Posts: 3,493

Re: Stand and Seal Health Problems


Major points for you Bill. Even on the links page too. Thank you very much for your support.

TFP Admin is offline   Reply With Quote
Old July 4, 2006, 01:31 PM   #28
A Floor Pro
TFP donor badge
guide emeritus badge
charter member badge
 
Bill Vincent's Avatar
 
Join Date: May 2006
Location: Bridgton, Maine
Posts: 328

Re: Stand and Seal Health Problems


No prollem!!

Thank my wife-- she's the one who dun it!!


Whether you think you can, or you think you can't, you're probably right.

http://www.creativeceramicandmarble.com
Bill Vincent is offline   Reply With Quote
Old July 4, 2006, 02:06 PM   #29
Administrator
 
TFP Admin's Avatar
 
Join Date: May 2006
Location: teh Ether
Posts: 3,493

Re: Stand and Seal Health Problems


Thank you Mrs. Vincent!

TFP Admin is offline   Reply With Quote
Old July 9, 2006, 02:32 PM   #30
Some guy
charter member badge
 
Join Date: May 2006
Posts: 154

Re: Stand and Seal Health Problems


If you dig aerosol grout sealers, Gundlach has one that don't kill you at all. It is California VOC compliant and everything. Personally, I think sealing grout is a ridiculous waste of time and money, but hey, I'm a Spectralock Pro junkie.

CHU

Chuck is offline   Reply With Quote
Reply

Bookmarks

Go Back   The Floor Pro Community » Public Forums for the floor Pro, Do-It-Yourselfer & Consumer » Ceramic and Stone Q&A

Netflix - $8.99 a month - Free Trial
Topic Tools


LinkBacks (?)
LinkBack to this Topic: http://www.thefloorpro.com/community/ceramic-and-stone-q-and-a/132-stand-and-seal-health-problems.html
Posted By For Type Date
Tile/grout sealing TileLab SURFACEGARD? - DoItYourself.com Community Forums This topic Pingback March 2, 2010 07:32 PM
Take a look! - Contractor Talk - Professional Construction and Remodeling Forum This topic Refback August 24, 2008 07:31 AM
Warning: Possible Dangerous Product - DIY Chatroom - DIY Home Improvement Forum This topic Refback May 29, 2008 11:10 AM
sealing grout - Page 2 - Contractor Talk - Professional Construction and Remodeling Forum This topic Refback March 25, 2008 05:31 PM
sealing grout - Page 2 - Contractor Talk - Professional Construction and Remodeling Forum This topic Refback March 5, 2008 10:58 AM
Warning: Possible Dangerous Product - DIY Chatroom - DIY Home Improvement Forum This topic Refback February 24, 2008 10:01 PM
Forum Links This topic Refback September 6, 2006 07:59 PM

Similar Topics to Stand and Seal Health Problems
Topic Topic Starter Forum Replies Last Post
health.... DJ Flooring Potpourri 20 February 3, 2009 07:47 PM
Top Seal on Laminate Floors tara Hardwood and Laminates Q&A 3 March 26, 2008 07:07 PM
New Solutions Earn CRI Seal of Approval TFP Admin Site News & Announcements 0 December 6, 2007 06:42 PM


All times are GMT -7. The time now is 04:54 AM.


Forums Powered by vBulletin ©2000 - 2010, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO ©2010, Crawlability, Inc.
Style design by Jim McClain - an enterpriseJM project
All Site Content ©2006-2010 TheFloorPro.com